Inficon Cygnus Editor Software Manual Bedienungsanleitung PDF herunterladen (Seite 21)

2 - 1

IPN 074-394-P1A

Cygnus Editor Operating Manual

Chapter 2

Setup

2.1 Introduction

When the Cygnus Editor is first installed on a system, there are a few things that

need to be set to customize it to the particular hardware configuration. In addition,

several aspects of how the program looks and acts can be customized to individual

preferences. This chapter discusses how to customize your system to the needs of

your location.

2.1.1 Initial Setup

The first time the Cygnus Editor is run the following steps should be taken to

set up the system:

1 Set up the communications ports for your system (see section 2.2 below).

2 Configure each controller (see section 2.3 on page 2-9).

3 Configure the user preferences (see section 2.4 on page 2-13).

2.2 Communications Setup

The communications interface is set up via the System Properties Pages, which

are accessed via the Tools >> System Properties, or from the System >>

System Properties menu on the System Setup Screen, or by clicking on the

System Icon on the System Setup Screen (see Figure 2-1).

Figure 2-1 Accessing System Properties and Communications Settings

The first time the Cygnus Editor is run it starts on the System Setup Screen and

prompts for a communications port (Com Port) to be configured. See Figure 2-2.

From this dialog select and add the Com Port to be used for communications with

the Cygnus Thin Film Controllers.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 81 82

Keine Kommentare

Inficon Cygnus Editor Software Manual Bedienungsanleitung Seite 21