Inficon Cygnus Editor Software Manual Bedienungsanleitung PDF herunterladen (Seite 50)

3 - 12

IPN 074-394-P1A

Cygnus Editor Operating Manual

Figure 3-13 Entering an Input Name

Figure 3-14 Accepting an Input Name

Output Types can also be assigned on this page. Each output can be configured

as:

Normally Open . . . . . . . . . . . . . . . . which means the relay is held open by the

controller, during periods of inactivity, and

then closed to indicate activity or provide a

signal.

Normally Closed. . . . . . . . . . . . . . . which means the relay is held closed by the

controller, during periods of inactivity, and

then opened to indicate activity or provide a

signal.

Configuring an Output to be Normally Open or Normally Closed is largely

determined by the state required, at the input receiving this signal, to start or stop

a device or process. Some Outputs are configured by the system based on

parameter settings made in the Hardware Parameters, as shown in the example of

Figure 3-11.

If a Controller is attached to the PC then the Input and Output names from the

controller can be read and displayed in the Input/Output Names page of the Editor.

If all parameters were queried from the Main Page then the names will be shown

on the Input/Output Names page when the page is opened. Any name assigned by

the system will be shown with a grey background and will be protected against

editing (see Figure 3-15). Otherwise, when the page is opened the names can be

read from the controller by pressing the Query All button on the Input/Output

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 81 82

Keine Kommentare

Inficon Cygnus Editor Software Manual Bedienungsanleitung Seite 50